The “Check” button and LED ring will blink simultaneously and the voice prompt “Sensors require bypass” will be played.Yellow - on, and you hear “ Sensors require bypass ”Īfter you’ve entered a valid PIN to arm the system, if there are sensors that must be bypassed in order to proceed with arming, the Keypad will display: The battery icon will not be illuminated when the keypad is unplugged unless the Keypad battery is low (yellow) or very low (red). Click here to learn how to update the firmware. We recommend updating your Keypad firmware to resolve this issue. The Keypad has no connection and cannot communicate with the Base Station. Receiving firmware update from the Base Station. The “X” button was pressed to cancel a PIN entry. ( Note, the ring LED is only used in Bypass when Power Save is off. One or more Contact Sensors need to be bypassed. Most often occurs when an incorrect PIN is entered. ( Click here to learn how the monitoring center responds to Ring Alarm.)Ī command failed to send or was rejected. Red, with a pattern - First, the LED ring is fully lit, then one segment at a time turns off in a counterclockwise direction as the countdown progresses, until all the segments turn off.Īlarming. If you have Ring Protect Plus and have signed up for professional monitoring, the monitoring center is being contacted. Then one segment at a time will light up in a clockwise direction as the countdown progresses, until the LED ring is fully lit. Red, with a pattern - First, the lights are off. Illuminates when the alarm system state changes to armed (Away or Home).Red - One segment at a time will quickly light up in a clockwise direction until the LED ring is fully lit.Īrmed - Away or Stay (one or more sensors monitored) Will not illuminate when Power Saving is On.Illuminates when the alarm system state changes to Disarmed.When Keypad is not yet added to the Base Stationĭisarmed - Home Mode (no sensors monitored) This can happen after an update, tapping the pinhole button on the back, or if the Keypad battery drained completely then powers back on after plugging in charging cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |